Glossary entry (derived from question below)
English term or phrase:
CTC
Russian translation:
center to center
- The asker opted for community grading. The question was closed on 2016-05-02 14:54:07 based on peer agreement (or, if there were too few peer comments, asker preference.)
Apr 29, 2016 12:12
8 yrs ago
English term
Ukraine
Be present
Native in: Russian 
, Ukrainian
Works in: English to Russian, Russian to English, German to Russian, and 5 more.
CTC
English to Russian
Tech/Engineering
Engineering: Industrial
Construction, steel frames
10 ctc slotted holes on beam side
Речь идет и соединениях между балками и колоннами металлоконструкции.
На швеллера и уголках имеются отверсия под высокопрочные болты (hsb bolts).
Что тут означает ctc?
Речь идет и соединениях между балками и колоннами металлоконструкции.
На швеллера и уголках имеются отверсия под высокопрочные болты (hsb bolts).
Что тут означает ctc?
Proposed translations
(Russian)
| 3 +1 | center to center |
Igor Boyko
|
Proposed translations
+1
16 mins
Igor Boyko
Russian Federation
Russian Federation
Native in Russian
Russian Federation
Editor-in-Chief service
Native in: Russian
Works in: English to Russian, Ukrainian to Russian
Related KudoZ points
:
112
Selected
center to center
Machining distances on bolt holes (or bores) should almost always be CTC (center to center)
http://www.1911forum.com/forums/showthread.php?t=359230
--------------------------------------------------
Note added at 19 мин (2016-04-29 12:32:03 GMT)
--------------------------------------------------
I have an assembly where a plate has slots and the other part has a hole and I am looking to mate them center to center.
https://forum.solidworks.com/thread/47565
http://www.1911forum.com/forums/showthread.php?t=359230
--------------------------------------------------
Note added at 19 мин (2016-04-29 12:32:03 GMT)
--------------------------------------------------
I have an assembly where a plate has slots and the other part has a hole and I am looking to mate them center to center.
https://forum.solidworks.com/thread/47565
4 KudoZ points awarded for this answer.
Comment: "Thanks"
Something went wrong...